Surgex SX-AX20 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour ordinateurs Surgex SX-AX20. SurgeX SX-AX20 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Axess Quick Start Guide Page 1
Connections
1. Connect Network. The Axess supports 10/100 Ethernet using the cable supplied, or
other suitable unshielded twisted pair (Cat 5) cabling.
2. Connect Powered Equipment. Connect the devices to be powered On and Off to the
8 receptacles located on the rear panel. If the connected equipment has a Power
switch, leave it in the On position to allow the Axess to control the power.
IMPORTANT: Ensure that the total combined load of all controlled devices does not
exceed 15/20 Amps (SX-AX15/SX-AX20).
3. Connect Serial Port (Optional). The Axess has a 9 pin D subminiature connector for
RS-232 serial control. The connector is configured as DCE for direct connection to a
laptop or other terminal device. Default serial parameters are 115,200 bps, 8 data, no
parity, 1 stop bit (115200,8,n,1).
4. Connect Power Mains. Connect power to the unit by plugging the power cord into a
120V AC, 15 (20) amp wall or floor receptacle. Do not plug the unit into a re-locatable
power tap.
Web Browser Access
Factory Default IP Address
Factory Default Security
Credentials
192.168.0.254
Role
Username
Password
Administrator
admin
admin
To access the Axess from the default IP Address, the PC must be on the same local network
(IP address of 192.168.0.nnn). If it is not, change the IP address using one of the methods
described below.
After pointing a web browser to the IP address of the Axess, enter the Administrator Username
and Password to access the power control.
Vue de la page 0
1 2 3

Résumé du contenu

Page 1 - Connections

Axess Quick Start Guide Page 1 Connections 1. Connect Network. The Axess s

Page 2 - Changing the IP Address

Axess Quick Start Guide Page 2 Changing the IP Address 1. Command Line I

Page 3 - (continued)

Axess Quick Start Guide Page 3 Changing the IP Address (continued) 3. S

Modèles reliés SX-AX15

Commentaires sur ces manuels

Pas de commentaire