Surgex PF-420 Manuel d'utilisateur télécharger pdf

SurgeX

Installation Instructions

PF420

Mounting

The SurgeX PF420 is designed to be mounted on a flat, vertical surface. Secure the

unit by fastening at the corners with appropriate screws. This product must not be

flush mounted or set between wall studs as overheating can occur under such

conditions. Use caution when removing knock-outs so that damage does not occur

to internal components.

Connection

The SurgeX PF420 provides four identical circuits, each rated at 120 Volts and 20

Amps, providing a total capacity of 80 Amps. This product shall be wired only by

qualified Electricians using 12 AWG conductors as specified in Article 310 of the

2005 National Electric Code, as set forth in Table 310.13. Any type of conductor

suitable for use in wet or dry locations such as (but not limited to) THHN, THHW,

THW, THWN, or TW shall be considered acceptable if local Code permits. Each

circuit must be protected by a 20 Amp circuit breaker.

A special terminal is provided for each circuit to carry an Isolated Ground

(technical ground) though the unit. These terminals have no connection to the

chassis ground or to the unit itself and their sole purpose is to provide a convenient

way of joining isolated ground wires.

The four higher terminal blocks are for the Line connections, with the

corresponding Load terminal block for that circuit directly below it.

1 2

SurgeX Installation Instructions PF420 Mounting The SurgeX PF420 is designed to be mounted on a flat, vertical surface. Secure the unit by fasten

Page 2

Line Connection Connect the electrical service from the load side of the circuit breaker to the upper terminal block as follows:  Live (Black) w

Pas de commentaire

Surgex PF-420 Manuel d'utilisateur